primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• The influence between Section spacing of secondary winding, primary winding and flux leakage of magnetic core to the secondary winding are simulated, the equivalent factor is introduced between the rectangular wire and the round wire.
  模拟分析次级绕组段间距、初级绕组以及磁芯漏磁对次级绕组损耗的影响，并引入了矩形导线和圆导线之间的等效因子。
• With consideration of ST's insulation and volume, the parameter of ST was determined by the theory analysis and computation of the primary winding.
  通过对初级绕组的计算分析及考虑体积、绝缘的基础上，确定了ST的相关参数。
• The harmonic compensation currents proportional to the harmonic current in the primary winding, which is detected real-timely, are injected to the multiple secondary winding of the transformer.
  实时检测变压器原方绕组的谐波电流，通过逆变器产生与原方绕组谐波电流成比例的谐波补偿电流注入变压器副方多补偿绕组中。
• Rising Current Method at CT Primary Winding and Its Application
  电流互感器一次升流的方法与应用
• Some proposals are given: selecting TV with good excitation characteristic, reducing grounding number of TV in same network, keeping the symmetry of line-earth capacitance and paying attention to insulation coordination in neutral point of primary winding.
  电磁式TV在使用中应注意选用励磁特性好的产品、减少同一系统中TV中性点接地的数量、保持系统三相对地电容的对称性，同时注意高压绕组中性点的绝缘配合问题。
• Analysis of an Oil-Immersed Current Transformer Primary Winding Failure
  油浸式电流互感器一次绕组故障实例分析
• The High Tension ( HT) voltage is produced by mutual induction between the primary winding and the secondary winding, and the central soft iron core intensifies the magnetic field between them.
  通过初级绕组和次级绕组之间的互感产生出一个高电压，把两绕组联系起来的中心软体起导磁的作用，它把磁场集中起来。
• Considering the conditions as voltage at primary winding, shortcircuit forces of windings and turns for transformer were calculated with FEM coupling circuit method under the 2D symmetrical model.
  以此起始条件设定变压器原边电压激励，利用磁路-电路耦合有限元法建立了2D轴对称模型，计算了变压器原、副边线圈及各线匝短路电磁力。
• The strength calculation method and the structure of current transformer with U primary winding to fulfil the dynamic stability requirements are introduced, and some calculating examples are given.
  介绍了U形一次绕组电流互感器可满足动稳定要求的结构及强度计算方法，并给出了计算实例。
• The transformer adopts multiple secondary compensation winding structure. The primary winding is in parallel with the harmonic load and the secondary compensation windings are connected with PWM inverters.
  变压器采用副方多补偿绕组结构，原方绕组与谐波负载相并联，副方补偿绕组分别与逆变器相联。